Partner for Modern Technology

Multiphase Blow Down Unit (MBDU)

  • Remove and boost liquids when gas wells stop flowing due to liquid loading.
Multiphase Blow Down Unit

Typical gas wells produce not only natural gas but also liquids such as water and hydrocarbons like propane and butane. Except in wells where the gas is dominantly dry, NGLs can build up down hole, reducing the gas flow to an extent where the well is shut in and cannot buck the line pressure of the export flow line.

The conventional method for alleviating this down hole liquid restriction is to disconnect the well from the pipeline and then free flow the well into a portable tank until the gas begins to free flow again. The pressure in the tanks is usually lowered by venting directly to the atmosphere releasing VOCs and creating environmental permitting issues. The liquids trapped in the tank then require removal, typically by truck. This increases heavy traffic, often in sensitive areas, and significantly impacts production costs.

This conventional blow down method, increasingly under attack in many states, is costly to execute and leads to potentially dangerous work environments. Other possible solutions, such as soap sticks, plunger lifts, pump jacks and ESPs are not always effective and expensive to install and maintain.

The simple solution is a Leistritz Multiphase Blow Down Unit (MBDU). This portable, self-contained unit simultaneously evacuates both the liquids and gases trapped within the tube and boosts the well pressure allowing the gas and trapped liquids to flow into the existing pipeline. This eliminates the need to vent or flare gas, transport hydrocarbons over public roadways and most importantly allows the operator to capture all the valuable gas and NGLs in their existing pipeline network.

A typical blow down cycle starts by connecting the MBDU in by-pass mode to the gas well export line. The MBDU starts pumping against full discharge (or pipeline) pressure with well shut-in pressure at the inlet. After a short period of time the MBDU builds differential pressure by drawing down the wellhead pressure. The gas starts flowing through the MBDU with increasing velocity, dragging along increasing amounts of liquid, eventually restoring the well to the desired flow and pressure conditions. Once the original conditions are restored, the MBDU is disconnected from the well and transported to another well site to repeat the same procedure.

Scope of Supply
  • Leistritz Multiphase Pump
  • Natural gas engine with battery, radiator, muffler, PTO and fuel conditioning system
  • Gear box
  • Couplings and guards
  • Trailer mounted structural steel skid with raised rim and common drain
  • Cooler
  • Suction piping with strainer and actuated ESD valve
  • Discharge piping with liquid knock-out boot (including demister), check valve, manual isolation valve and full flow relief valve (piped to suction)
  • Bypass piping with check valve
  • Instrumentation (reference applicable P&ID) and on skid wiring to PLC
  • Seal drain collection tank with monitoring
Required Utilities
  • Initial liquid fill of liquid knock-out boot
  • Fuel gas from sales gas line
System and Area Classification
  • 300 lb. System
  • Class I, Division II
Optional Items
  • Inlet pressure control valve
  • Electric motor or diesel engine driver
  • Double mechanical seal with throttle bushing and API plan 53B seal oil system
  • Drag skid
  • Actuated valves
Multiphase Blow Down Unit

Multiphase Blow Down Unit

Back to Top -